User Manual

2-15
Installing the Series 4100GL Switches
Installation Procedures
Installing the Series 4100GL
Switches
2. Partially install a screw (5/8-inch number 12-24) into the top hole of a pair
of holes that are 0.5 inches apart in each rack/cabinet upright as shown
in the illustration below. Ensure that the screws are at the same level in
each upright.
.
3. Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
lower the switch with
mounting brackets onto the
partially installed screws,
then tighten these screws
stingray.book Page 15 Sunday, March 24, 2002 1:54 AM