HP SureStore HD Server 4000 User's Guide - 5967-9979

Adding a Tape Drive 8
-
9
8. Attach one end of the SCSI cable accompanying your tape drive
to the rear of the tape drive unit.
9. Attach the other end of the SCSI cable to the SCSI connector on
the rear of the server. If it does not have the correct connector,
refer to the “Ordering Information” in the electronic
User’s Guide
on the
HP SureStore Tape CD-ROM
for the correct cable.
10. Ensure that a SCSI terminator is attached to the tape drive unit
(or the end of the SCSI bus). The terminator you remove from the
HD Server’s SCSI connector (HP part no. 5063-5324) may be
moved to the tape drive. Otherwise, you may use the SCSI
terminator attached to the rear of the tape unit (shown below).
11. If the server has not yet been installed, go now to the installation
procedure on the
Quick Setup
guide, or in this manual go to
“Connecting and Starting Up” on page 2-8 and continue with
chapter 2.
12. Attach the power cord to the tape drive unit and to a power source.
Power up the unit (before switching on the server’s power).
13. On the front of the server, switch on power and verify normal
operation (page 6-4). Notify users that file service is resumed.
14. Refer to chapter 9 for configuration of backup functions.
Note ❏
Tape drives must be cleaned regularly for reliable service.
Follow cleaning instructions in the electronic
User’s Guide
on
the
HP SureStore Tape CD-ROM
.
SCSI connector with
terminator installed.