HP SureStore HD Server 4000 User's Guide - 5967-9979

28 Resolving Problems with Your Server

Replace the Tape

Drive

1. Assemble the following tools:

• Torx

#15 driver or flat-blade screwdriver for filler panel

• Flat-blade screwdriver for opening the enclosure

• Torx

#10 driver for attaching drive mounting tray

• HD Server’s enclosure key for opening the keylock

2. Do the procedure “Open the Enclosure” on page 11-25.

3. Detach the old tape drive module at the front of the server

(illustrated below), using the Torx

#15 or screwdriver to remove

the two screws. Reserve them for attaching the new tape drive.

4. Inside the enclosure on the rear of the tape drive, the connection

nearest you is the power cable connection (see illustration below).

Detach the power connector from the tape drive.

If you find that a short power extension cable is attached to the

enclosure’s power cable (see illustration above), then you may

find it easier to instead detach the extension from the

enclosure’s power cable.

Remove

screws

(5) Detach

SCSI cable

connector

(4) Detach power

connector here

or here