HP SureStore HD Server 4000 User's Guide - 5967-9979

Resolving Problems with Your Server 11

9. Open the side door:

Loosen the door mounting screws using a flat-blade

screwdriver. The screws remain attached to the door. Swing the

door open, away from the front of the server. (See the

illustration below.) For the most working space, you may lift the

door up and off the enclosure at the rear, and set it aside.

Close the

Enclosure and

Start Up

1. Assemble the following tools:

• a flat-blade screwdriver to reattach the enclosure door

• HD Server’s enclosure key for locking the keylock

2. If the door has been removed from its hinges, then with the door

parallel to the rear panel of the server, insert the three tabs into

their slots on the outside rear edge.

3. Swing the door closed and click it into place. Secure the door by

tightening the two captive screws.

4. Install the front bezel by attaching it at the bottom first, swinging

it upward, and then snapping it onto the enclosure at the top.

(See the illustration below step 8 on page 11-26.)

5. Lock the enclosure keylock if desired to prevent removing

components inside the enclosure.

6. On the rear of the server, reattach the power cables.

7. On the front of the server, switch on power and verify normal

operation (page 11-1). Notify users that file service has resumed.

Opening the

side door,

once the front

bezel has

been removed