HP SureStore CD/DVD-Rom Server Quick Installation Guide: Microsoft Networking, Novell NetWare - 5967-9968

Quick Installation Guide 1
Quick Installation Guide
Information in this
Quick Installation Guide
is available in greater detail in the
HP Surestore CD/DVD-ROM Server User’s Guide.
Step 1. Set up the Hardware
1. Verify with your network administrator that a 10Base-T (Ethernet) or 100Base-TX
(Fast Ethernet) network connection is ready for the server. Locate the twisted-pair
network cable. It has an RJ-45 connector.
2. Verify that the tower’s power is
off
. (The power switch should be
out
, not
in
.)
3. Verify the power configuration.
a. Verify that the input voltage switch is set according to the power standard of the
country of use. If necessary, set the input voltage switch on the rear of the tower to
either 115 volts or 230 volts (see the illustration below).
b. Verify that the power cord is appropriate for the country of use.
4. Attach the power cord to the rear of the tower and to the power line source.
Do not switch on power yet.
5. Attach the network cable to the RJ-45 network connector on the rear of the tower.
Input voltage switch
Power cord connector
RJ-45 network connector
SCSI connector for expansion tower
(see chapter 2 in the
User’s Guide )
Recessed factory reset button
(see “Restore Factory-Default Settings”
in chapter 10 in the
User’s Guide )