User Manual

Table 26 Application modules—Error log messages (continued)
DescriptionNo.Log messageID
Unable to create an object for
initiator object; exceeded the
maximum number of initiators
117QLBA_CreateInitiatorObject: Too many initiators41077
Process control block status
indicates that a PCI error occurred
during a target operation
136QLBA_DisplayTargetOperationStatus: PCI Error, Status
0x%.2x
41096
Process control block status
indicates that a DMA error
146QLBA_DisplayInitiatorOperationStatus: DMA Error, Status
0x%.2x
41106
occurred during an initiator
operation
Process control block status
indicates that a transport error
147QLBA_DisplayInitiatorOperationStatus: Transport Error, Status
0x%.2x
41107
(protocol) occurred during an
initiator operation
Process control block status
indicates that a data overrun error
151QLBA_DisplayInitiatorOperationStatus: Data Overrun, Status
0x%.2x
41111
occurred during an initiator
operation
iSCSI Login failed between receipt
of PDU and request for the data
segment.
274QLIS_LoginPduContinue: Operation failed. Initiator 0x%x,
TPB status 0x%x
41234
iSCSI Login failed due to
unsupported version number in
received login PDU.
278QLKV_ValidateLoginTransitCsgNsgVersion failed (status
0x%x)
41238
iSCSI Login PDU contains invalid
initiator name. The format and
297QLIS_LoginPduContinue: Invalid initiator name. Initiator:41257
character set used to form the
initiator name is invalid.
iSCSI target Login was attempted
to a portal (iSCSI1 or iSCSI2) on
which the target is not presented.
305QLIS_LoginPduContinue: Target not configured for Portal41265
iSCSI Login PDU received for a
target with a target name unknown
to the router.
307QLIS_LoginPduContinue: Target not found. Target name:41267
iSCSI Login PDU received without
a target name for a normal
session.
308iSCSI Login PDU received without a target name for a normal
session.
41268
iSCSI Login PDU received without
an initiator name key or value.
310iSCSI Login PDU received without an initiator name key/value
not provided.
41270
iSCSI Login PDU received with an
incorrect initiator task tag for a
312QLIS_LoginPduContinue: CONN_STATE_IN_LOGIN,
Unknown InitTaskTag
41272
session which is partially logged
in. This would occur if a login PDU
other than the initial login PDU
used an initiator task tag that was
different than the initiator task tag
provided in the initial login PDU.
iSCSI Login PDU was received with
a TSIH out of range. This would
323QLIS_LoginPduContinue: TSIH 0x%x out of range41283
occur if the iSCSI initiator
attempting the login failed to used
the TSIH value provided in the
120 Log data