User Manual

Show VLAN command
Displays the mpx110’s VLAN configuration.
NoneAuthority
show vlan [<port_num>]Syntax
port_num
Specifies the iSCSI port number whose VLAN configuration is to be displayed
Parameter
The following is an example of the show vlan command:Example
mpx110 #> show vlan
VLAN Information
------------------
Port 1
VLAN Disabled
ID 0
Priority 0
Port 2
VLAN Disabled
ID 0
Priority 0
mpx110 #> show vlan 1
VLAN Information ------------------
Port 1
VLAN Disabled
ID 0
Priority 0
Shutdown command
Provides for an orderly shutdown of mpx110 firmware. This command does not power down the
mpx110.
Admin sessionAuthority
shutdownSyntax
The following is an example of the shutdown command:Example
mpx110 (admin) #>shutdown
Target command
Removes targets from the mpx110 database. This command is typically used to remove targets
that are no longer connected to the mpx110.
NOTE: The target add command is not currently supported.
Admin sessionAuthority
targetSyntax
rmParameter
Removes a target from the mpx110 target database
The following is an example of the target rm command:Example
mpx110 (admin) #> target rm
Index (WWNN,WWPN/iSCSI Name)
---------------------------
0 20:00:00:20:37:fd:8b:ab:00:00:00:00:fc:b6:1f:fa
Please select an 'OFFLINE' Target from the list above
('q' to quit): q Command aborted.
Commands 111