Owner's manual

Preparing Programs

HP NonStop AutoTMF Software User’s Guide—429952-016

3-3

Using the PREPARE Command

The following sample terminal session shows PREPARE used on a single object file:

Use the INFO PROGRAM command to verify the state of the object file, for example:

If your application consists of many programs, you can prepare entire subvolumes

through one command; however, you should keep a record of the preparation by using

the LOG command, for example:

The PREPARE command processes only object files and ignores all other files. If

some files are not prepared because of errors, correct the problem, then re-issue the

PREPARE. You may prepare a program as often as you wish.

9> escort

HP Nonstop(tm) AutoTMF(tm) Command Interpreter(T0581V03) - System \RDF10

AutoTMF 1? prepare data.myobj.batchobj;

--- $DATA.MYOBJ.BATCHOBJ preparation complete

--- AutoTMF runtime library $SYSTEM.ESCORT.ESCRUNTM

AutoTMF 2?

AutoTMF 7? info program myobj.batchobj,detail;

$DATA.MYOBJ.BATCHOBJ Apr 29 2004, 14:07

Accelerated TNS Program

User Library $SYSTEM.ESCORT.ESCRUNTM

Prepared

Intercept proc calls prepared: 33

Attributes: Inspect, Saveabend

Binder timestamp: 23Apr04 8:27

AXCEL timestamp: 23Apr04 8:27

AutoTMF 1? log to srvobj.preplog;

AutoTMF 2? prepare srvobj.*;

<< Messages for each program >>

Object file summary: prepared = 72, unprepared = 3, excluded = 4

AutoTMF 3? log stop;