Owner's manual

NonStop AutoTMF Commands
HP NonStop AutoTMF Software User’s Guide—429952-016
6-45
ALTER MONITOR
ALTER MONITOR
Alters attributes of the monitor process. Changes take effect when the monitor process
is restarted.
These attributes can also be changed using the ALTER MAPDB command.
process-name
the AutoTMF monitor process. The name must have 5 characters, including the $.
The default is the current CI session monitor.
option
BACKUP 0-to-15
the cpu number of the backup monitor process.
HOMETERM file-name
the home terminal for the monitor process.
If omitted or NONE, the home terminal is set to the default EMS collector. The
default EMS collector is $0, or the EMS collector configured by setting the
global parameter EMSCOLLECTOR.
Note that internally, the default hometerm of the monitor is $ZHOME, as
displayed by the TACL command STATUS $<process-name>, because an
EMS collector cannot be specified as the hometerm of a process when the
process is launched. Functionally however, the home terminal for the monitor
process is the default EMS collector, as shown by the AutoTMF STATUS
MONITOR command.
PRIMARY 0-to-15
the cpu number of the primary monitor process.
PRIORITY 1-to-199
the priority of the monitor process.
All the options stored in the MapDB are used when the monitor process is started,
unless they are overridden by a START MONITOR command option.
ALTER MONITOR [process-name] { , option };
option is
{ BACKUP 0-to-15 }
{}
{ HOMETERM [ file-name | NONE ]}
{}
{ PRIMARY 0-to-15 }
{}
{ PRIORITY 1-to-199 }