User guide

COUP and PUP Interfaces
HP NonStop Storage Management Foundation User's Guide—523562-007
B-47
SHOWVIRTDISK Command
$storage-pool-name
identifies a particular storage pool process. If you omit this value, information about
all storage pools on the system is retrieved.
Figure B-7 is an example that illustrates how the information retrieved maps to storage
pool attributes when the following command is submitted:
SHOWPOOL
For more information on storage pool attributes, refer to Storage Pool Attribute Set on
page B-27.
SHOWVIRTDISK Command
The SHOWVIRTDISK command retrieves information about the attributes of one or all
virtual disks on a system. $ZSMS must be in the UP execution state, and its catalog
must be accessible. You need no special privileges to execute the SHOWVIRTDISK
command.
$virtual-disk-name
identifies a particular virtual disk process. If you omit this value, information about
all virtual disks on the system is retrieved.
Figure B-7. Results of PUP SHOWPOOL Command
SHOWVIRTDISK [$virtual-disk-name]
013CDT .CDD
NAME CATALOG LOC Adt Mrr Nom Dsk DInt Ext Eint Updt Strtdn
$AFCEW $DAT52.ZSMSP05 A 10 70 10 10 0 TRUE
$NFCW $DATA52.ZSMSP03 A OFF OFF 10 10 0 TRUE
$POOL1 $DATA52 A R D 70 5 OFF OFF 30 FALSE
Storage Pool
Process Name
CATALOGLOC
AUDIT
(ALLOWED)
MIRROR
(REQUIRED)
NOMADIC
(DISALLOWED)
DISKTHRESHOLD
(70 percent)
DISKINTERVAL
(5 percent)
EXTENTTHRESHOLD
EXTENTINTERVAL
UPDATESTATS
(30 minutes)
STARTDOWN