Owner's manual

Managing Requests
DSM/SCM User’s Guide — 529846-014
16 - 7
Restarting a Request
These messages indicate that an error occurred, user intervention is required, or both:
For more information about the status message for a pa
rticular request, check the
EMS messages generated while the request was running. For a description of EMS
messages related to DSM/SCM, see the DSM/SCM Messages Manual.
Restarting a Request
You can restart DSM/SCM requests that the planner cancels or that stop in a
restartable state. A restartable request is indicated by the message:
Processing stopped in a restartable state
To check the status of a request and restart it:
1. Check the status of the request. See
Checking the Status of a Request on
page 16-4.
Message Meaning
Awaiting operator
tape mount
The re
quest resumes when the tape is mounted.
Cancel processing
stopped in
restart
able state
You canceled the request, but the cancel activity stopped before it could
complete restoring DSM/SCM to a consistent state. After taking
corrective action, you can restart the cancel. You must correct the
problem before attempting further DSM/SCM activities.
Cancel processing
stopped in
nonrest
artable state
You canceled the request, but the cancel activity stopped before it could
complete restoring DSM/SCM to a consistent state. An internal error
probably occurred, which might require assistance from HP support.
You must correct the problem before attempting further DSM/SCM
activities.
After diagnosing the problem, use the Maintenance Interface to delete
the request.
Complete with
warnings
The re
quest completed successfully, but conditions occurred that might
affect th
e results.
Complete with
errors
The request completed, but conditions occurred that require attention.
Processing stopped
in rest
artable st
ate
The request stopped before it completed. Take corrective action and
then restart the request.
Processing stopped
in nonre
st
artable
state
The request stopped before it completed. An internal error probably
occurred, which might require assistance from HP support. Correcting
the error might require Maintenance Interface activities.
After diagnosing the problem, cancel the re
quest. If the cancel fails, use
the Maintenance Interface to delete the request.
Note. If you must use the Maintenance Interface to correct an error, first close all open
Planner Interface windo
ws (except the main window).