Owner's manual

Configuring DSM/SCM
DSM/SCM User’s Guide — 529846-014
5 - 31
Reinitializing DSM/SCM
Table 5-3. Reinitialization Checklist (page 1 of 2)
___ Would you like to read the introduction? Yes or No
___ Are you changing or initializing the system?
Choose to reinitialize to:

Change a target system to a host system

Change the TMF volume or the SQL system catalog
volume

Initialize after reinstalling DSM/SCM because of an
operational error.
I
___ Database will be destroyed, continue?
Destroying the host database, target database, and
archive is necessary to reinitialize, so confirm it.
Y
___ Host or ph
ysical target system?
The default is to configure the system as a host.
Host or Target
If initializing a host system:
___ Winsock or RSC?
Winsock is the default. Use the default. INITENV then
asks yo
u to prov
ide this information:

Volume for SERVICES and PORTCONF files

Host Database Volume
The default volume is $DSMSCM. Use the default or
specify the name of the volume that con
tains the
host database. The volume must be audited by TMF.

IP Port Number
Winsock
___ Configure Winsock server? Yes
___ Database volume? This volume must be audited by TMF. $DSMSCM
___ Volume for SERVICES and PORTCONF files? Enter, to accept default
___ IP Port Number?
The default IP port is 1089. The location of the Winsock
SER
VICES and PORT
CONF files, and the IP port
number to use. If you do not use the default, you must
use an unused number between 1025 and 65535.
Enter the same IP port number used for the Planner
Interface on the PC. See
Task 2: Install the Planner
Interface on the PC on page 4-7.
1089