Manual

D TN6530 Control Codes and Escape Sequences
This appendix summarizes the 653X terminal control codes and escape sequences that are supported
by TN6530. “ TN6530 Control Codes and Escape Sequences” (page 187) lists the control and
escape sequences that TN6530 does not support; Table 25 lists the control and escape sequences
that are supported.
Table 24 Unsupported Control and Escape Sequences
FunctionControl/Escape Sequence
Cancel lineCAN (18H)
Set single-width charactersESC - X
Set 80-column formatESC - Y
Set 132-column formatESC - Z
Print pageESC - 0
Disconnect modemESC f
Set double-width charactersESC t
Set I/O device configurationESC x
Read I/O device configurationESC y
Table 25 Supported Control and Escape Sequences
FunctionControl/EscapeSequence
Sound bell (audible alarm)BEL (07H)
Backspace (cursor left)BS (08H)
Horizontal tabHT (09H)
Line feed (cursor down)LF (0AH)
Carriage returnCR (0DH)
Set buffer address*DC1 (11H)
Set cursor addressDC3 (13H)
Escape sequence headerESC (1BH)
Start field*GS (1DH)
Set buffer address extended*ESC - C
Clear memory to spaces extended*ESC - I
Set cursor address extended*ESC - D
Read with address extended*ESC - J
Read with address all extended*ESC - K
Set tabESC 1
Clear tabESC 2
Clear all tabsESC 3
Set video attributesESC 6
* Sequences used in block mode only
** Sequences used in conversational mode only
187