Manual

Other Supported Tandem Data Communication Subsystems
Subsystems
098571 Tandem Computers Incorporated 5–23
States Table 5-20 shows how DSNM reports Tandem data communications subsystem states.
Table 5-20. How DSNM Reports Tandem Data Communications Subsystem States
Subsystem State DSNM State
UNKNOWN UNKNOWN∗
DIAGNOSING PENDING
STOPPED DOWN
SUSPENDED PENDING
SUSPENDING PENDING
ABORTING PENDING
STOPPING PENDING
STARTING PENDING
STARTED UP
DEFINED UP
∗ If the subsystem does not return one of the above subsystem states in response to a status request,
the state is reported as “UNKNOWN.”
Effects of the Hierarchy
Modifier
To determine which modifiers are supported in a particular subsystem, see the
management programming manual for the subsystem.
Supported Commands See Section 2, “Commands,” for a list of supported DSNM commands.