Owner's manual

Troubleshooting
N1528A and N1529A ACL Tape Drive Installation and User’s Guide—544594-002
6-4
Stuck Tape Removal Procedure
comes free of the magnet. This will need to be overcome to get the cartridge in the
fully ejected position.
8. Remove the cartridge by hand.
9. Reassemble the shoe kit back onto the brick.
10. Gently place the shoe kit back into the chassis.
Carefully tighten the screws on the shoe kit with a flat-head screwdriver, do not
tighten them too tight. See Figure 6-1 on page 6-1 for the location of the screws.
Figure 6-4. LTO Tape Drive (Brick)
RD Thumbwheel Access
Rear of
Brick
Front of
Brick
Front Reel Motor Access
T-10 Torx Driver