Owner's manual

Installing and Configuring the ACL Tape Drive for the

NonStop S-Series Server

N1528A and N1529A ACL Tape Drive Installation and User’s Guide—544594-002

3-5

Installation Procedure for Old Model

1. Check that the power switch on the tape drive is set to the off position. See

Figure 3-3.

2. Connect the power cord to the tape drive’s AC power receptacle. See Figure 3-3.

3. Make sure the power cord is fully seated.

4. Connect the 68-pin to 68-pin SCSI cable to the top SCSI port on the SCSI

Converter card. See Figure 3-5

5. Connect the other end of the SCSI cable to a supported SCSI port on the server.

You can attach the tape drive to a NonStop S-series server using one of the

following:

Note. Do not attach the male end of the power cord to a power outlet at this time.

Figure 3-3. View of Power Switch and Power Receptacle

Power Switch AC Power Receptacle