Instruction Manual

Troubleshooting
M8701A / M8702A ACL Tape Library Installation and User’s Guide—694636-001
5-13
Main Error Code Descriptions
If you press Next, the OCP will display additional information, if available, as shown in
Figure 5-7.
If you press Next again, the OCP will display the date and time in the format: YYYY-
MM-DD followed by the time in 24–hour clock format, where 1:00 pm is 13:00, as
shown in Figure 5-8.
Main Error Code Descriptions
Figure 5-7. No Additional Information in the OCP Error Log
Figure 5-8. Date and Time in the OCP Error Log
Table 5-2. Main Error Codes
Error Code Description Details and Solution
80 Cannot initialize bar code reader Power-cycle the unit and retry the
operation.
81 No response from bar code reader Power-cycle the unit and retry the
operation.
82 No response from EEPROM on robotic
controller
Power-cycle the unit and retry the
operation.
83 Robotic controller generic problem Power-cycle the unit and retry the
operation.
84 Setting of gripper motor parameters
failed
Power-cycle the unit and retry the
operation.
85 Setting of slider motor parameters
failed
Power-cycle the unit and retry the
operation.