Instruction Manual

Operation
M8701A / M8702A ACL Tape Library Installation and User’s Guide—694636-001
4-25
Configuration
The following settings are not reset:
!
Administrator password
!
Network settings (network is always enabled and the network addresses are
retained)
!
Date and time
To save the device configuration to a file, click Save and follow the instructions on the
RMI to specify a file location.
To restore the device configuration from a file, browse to the location of the saved
configuration file and click Restore.
The configuration settings that are saved to file are:
!
Administrator password
!
Mailslot configuration
!
All network settings, including DHCP, DNS, IPv4 and IPv6 addresses
!
Barcode reader label length and barcode reader alignment
!
Reserved slots
!
Display contrast setting
!
Library mode
!
All drive configuration settings
!
Auto clean
!
SNMP addresses and configurations
!
Log tracing configuration
!
Email notification configuration (SMTP address, email address, filter level)
!
Option to allow the magazine access without the administrator password
!
Option to ignore the barcode media ID
!
Logical library configuration
IMPORTANT: When the defaults are restored, the Library will rediscover and renumber the
tape drives from the bottom of the Library up. If a tape drive was added between two other tape
drives since the last time the drives were discovered, that tape drive and the ones above it will
be renumbered. You might need to update the configuration of the backup application when
tape drives are renumbered.