Instruction Manual

Operation
M8701A / M8702A ACL Tape Library Installation and User’s Guide—694636-001
4-24
Configuration
the network or ensure that only one device with the same network configuration is on
the network at a time until they have unique network identities.
The restored factory default settings are:
!
SCSI address: 4
!
Fibre Channel drive configuration: Automatic speed, auto port type
!
Master drive: reset to Drive 1 or the lowest numbered existing drive
!
Drive power: all drives powered on
!
Active slots: maximum possible
!
Library mode: Automatic
!
Loop: No
!
Event log levels and filter: continuous trace and all levels and filters active (for
Service use only)
!
Barcode reader label length: 8
!
Barcode reader alignment: Left
!
Error recovery: On
!
Mailslot configuration: mailslot disabled
!
Auto clean: disabled
!
SNMP: disabled, but saved addresses do not change
!
E-mail notification: disabled, but configurations retained
Note. You can save the device configuration to a USB flash drive from the OCP.
Figure 4-18. Configuration: Restore Defaults Page