Instruction Manual

Operation
M8701A / M8702A ACL Tape Library Installation and User’s Guide—694636-001
4-20
Configuration
You may change the:
!
SNMP Enabled — When checked, the device can be managed by computers listed
in the SNMP Target IP Addresses field.
!
SNMP Target IP Addresses — the IP addresses for up to three computers running
IPv4 SNMP management software and up to three computers running IPv6 SNMP
management software. IP addresses will not be cleared if SNMP is disabled, but
those targets will no longer be able to manage the Library and will not receive traps
from the Library. You can select the SNMP version for each target address.
!
Community Name — a string used to match the SNMP management station and
device. It must be set to the same name on both the management station and the
Library. The default community name is public.
Figure 4-13. Configuration: Network Management Page