Instruction Manual

Operation
M8701A / M8702A ACL Tape Library Installation and User’s Guide—694636-001
4-19
Configuration
!
Enable HTTPS — when On, the RMI can only be accessed through an HTTPS
connection.
For IPv4, you may change the:
!
DHCP Address — when On, the Library will request an IP address from a DHCP
server each time the device is booted. The default is On.
!
Static Address — configures the IP address if DHCP is not enabled.
!
Subnet Mask — configures the network mask of the library controller if DHCP
Address is not On.
!
Gateway Address — configures the gateway address if DHCP Address is not On.
!
IPv4 DNS Server 1 and IPv4 DNS Server 2 — configures the addresses of up to
two DNS servers if DHCP Address is not On.
For IPv6, you may change the:
!
IPv6 DNS Server 1 and IPv6 DNS Server 2 — configures the addresses of up to
two DNS servers if DHCPv6 is not enabled.
!
Stateless Addressing Enabled — when On, the Library will generate an address for
itself based on the routing information obtained from a router advertisement and
the MAC address. The Library can manage up to five global addresses at the
same time, which can be assigned from different routers. The default is On.
!
DHCPv6 Addressing Enabled — when On, the Library will request an IP address
from a DHCP server each time the device is booted. The default is Off.
!
Static Addressing Enabled — when On, the Library will use a statically-configured
address. The default is Off.
!
Static Assigned Address — configures the address when Static Addressing
Enabled is On. You can select the standard prefix, FE80:, or the prefix of a nearby
router. Enter the remainder of the address and click Add.
To remove an IPv6 static IP address, click Delete next to the address in the Current
IPv6 Addresses pane.
Configuration: Network Management
Use the Configuration: Network Management page to enable and configure SNMP
(Simple Network Management Protocol), which allows network management
applications to manage the device. The device supports both SNMP configuration and
SNMP traps. SNMP can only be configured with the RMI; it cannot be configured with
the OCP.