Owner manual

ViewSys Definition Language (VDL)
ViewSys User’s Guide—526358-002
D-4
MAXIMUM Statement
value
Specifies the value of the metric property; for example, CPUQUEUE 10.
When value equals CONFIG, the MAX value for the metric property is the
configured system value for that metric property.
When value equals DEFAULT, the MAX value for the metric property is the
default value specified in the following table.
The following table lists the metrics that you can use with the CONFIG value:
Considerations
Default values from the preceding table are used when the CPU cpu-num has been
specified for any metric property not defined, unless the CPU TYPE and SUBTYPE of
cpu-num were previously defined using the MAXIMUM CPU TYPE statement. In that
case, the maximum values from that statement are used. The default values from the
preceding table are used only when the CPU TYPE and SUBTYPE are not known.
CPUBUSY 100 Percent CPU busy
DISPATCH 20000 Average number of process dispatches per second
DISKIO 1200 Disk I/O rate for this CPU per second
MEMLOCKED CONFIG Number of physical memory pages currently locked
MEMQUEUE 60 Average memory manager queue length
MEMPRESSURE 7 Memory pressure rate
PAGEFAULT 250 Page fault rate
PCBLOW 255 The number of PCBs allocated in low PIN process
PCBHIGH CONFIG The number of PCBs allocated in high PIN process
SENDBUSY 160 The percentage of time a send was being performed
PTLE CONFIG The number of time-list elements in use
TLE CONFIG The number of time-list elements allocated
Metrics for CONFIG
Option Description
BREAKPOINT Number of allocated break points
CPUBUSY Percent CPU busy
MEMLOCKED Number of physical memory pages currently locked
PCBHigh Number of PCBs allocated in high PIN process
PCBLow Number of PCBs allocated in low PIN process
PTLE Number of time-list elements in use
TLE Number of time-list elements allocated
Metric Name
Default
Value Description (page 2 of 2)