User guide

Error Recovery Procedures and Fault Symptom
Codes
N1525A ACL Installation and User’s Guide—527339-003
C-5
Control Error Codes
Control Error Codes
FSC Message Description ERP
2001 Ctl. Invalid Command An invalid command was received by the control
process.
D, 1
2002 Undefined Config An unsupported configuration was detected. A, B, 6, 1
2003 Invalid Drive State One of the LTO drives was in an invalid state
This is caused by either attempting to fetch a
cartridge from an empty drive, or stowing to a
drive that already has a cartridge loaded.
A, B, 3, 5
2004 Loader Not Ready Currently not displayed. D, 1
2005 SCSI Id Not Set An attempt to set the LTO SCSI id failed. D, 1, 3
2006 LTO Comm. Open Error An attempt to open a COM port failed. A, B, 1, 3
2007 Door Fault An error occurred while attempting to move the
door.
D, 15, 1
2008 Illegal Move While attempting to perform a MOVE operation,
the source or destination locations were in the
wrong state (FULL or EMPTY).This also occurs if
the MOVE is attempted with an invalid cartridge
map
D, 5, 1
2009 Door Open A command was received while the door was
open.
D, 5, 15, 1
200A Menu Mode A command was received while the unit was in
Menu mode.
D, 5, 1
200C Cart Unaccessible An attempt was made to fetch a cartridge from a
drive that is not in the unloaded state. This only
applies when the system is configured for explicit
unloads.
D, 5, 6
200D Drive In Error An attempt was made to access a drive which is
in an error state.
D, 3, 1
200E No Magazine The element is not available because the
magazine is not installed.
D, 7
200F Removal Prevented Medium removal was attempted when in a
Prevent Removal State.
D, 5
2010 Ctl. Firmware Error An invalid configuration was detected. The
configuration jumpers on the main board may not
be set properly.
A, B, 6, 1
2011 Ctl. Firmware Error A status block was received by the Control
Process operating in a Stand-Alone or Slave
configuration. Since commands are never sent in
these modes, status cannot be received.
A, B, 1
2012 Ctl. Firmware Error A command was received which was invalid for
the current configuration.
A, B, 1