User guide

Error Recovery Procedures and Fault Symptom
Codes
N1525A ACL Installation and User’s Guide527339-003
C-4
SCSI Error Codes (1xxx)
SCSI Error Codes (1xxx)
FSC Message Description ERP
1001 SCSI Firmware Error D, 17, 1
1002 SCSI FIFO Empty While getting SCSI command bytes, the SCSI
chip reported an empty FIFO before it was
expected.
D, 17, 1
1003 SCSI FIFO Error While getting SCSI command bytes, the SCSI
chip reported that the FIFO was not empty when it
should be empty.
D, 17, 1
1004 SCSI Gross Error Gross error status was returned by the SCSI chip.
This usually means that the SCSI chip is in an
illegal state.
D, 17, 1
1005 Illegal SCSI Cnt Cmd The SCSI chip rejected a command from the
firmware
D, 17, 1
1006 SCSI Message Error Not reported D, 17, 1
1007 SCSI Invalid Element Firmware error D, 17, 1
1008 SCSI No Pending Int An interrupt was returned from the SCSI chip
when one was not expected.
D, 17, 1
1009 SCSI Invalid Int An invalid interrupt was returned from the SCSI
chip.
D, 17, 1
1020 No Active Command Status was returned from the control process
when no command was active.
D, 17, 1
1021 SCSI Invalid Request An invalid request was received from the control
process (firmware error).
D, 17, 1
1022 SCSI Invalid Semaphore Firmware Error D, 17, 1
1023 SCSI Invalid State Firmware Error D, 17, 1
1024 SCSI Invalid Ctl Msg A message sent from the control process was not
valid.
D, 17, 1
1025 Overlapped Ctl Cmds The control process sent a command while one
was in process.
D, 17, 1
1026 Overlapped Ctl Msgs The control process sent a message while one
was in process.
D, 17, 1
1027 Control Process Busy The SCSI control process is busy D, 17, 1
1028 Control Initializing The SCSI control process is initializing D, 17, 1
1029 Control Seq. Mode The SCSI control process is sequencing D, 17, 1
1030 Invalid SCSI ID The SCSI in NOVRAM is set to >= 8 and the
PWB is not configured for Wide SCSI. Would
only occur during SCSI initialization.
D, 17, 1