Manual

Installing and Configuring the Tape Drive

5158ACL Tape Drive Installation and User’s Guide—524955-002

2-3

Configuring the Tape Drive

This section describes how to configure the tape drive. For information on the

different menu’s featured on the tape drive, refer to Section 3, Operating the

Tape Drive.

The library (robotics) is factory set to SCSI ID 3; the tape drive is factory set to

SCSI ID 5. The drive is factory set for parity generation and checking is enabled.

Setting the SCSI ID

1. Turn the tape drive on. Wait until the power-on self-test terminates and the

default screen appears. Figure 2-3 shows the default screen for the unit,

which indicates a tape magazine with only one cartridge in slot 1.

Rectangles appear on line three on the default screen in positions that

correspond to the slots where cartridges are present.

2. At the Default screen, press Enter. The the Main menu in Figure 2-4

appears.

3. Press the down button four times to move the

cursor to Configure menu, then

press Enter. The Configure menu in Figure 2-5 appears. The arrow at the

Figure 2-3. Default Screen

Figure 2-4. Main Menu