Specifications

3. Install the access panel (“Replacing the server blade access panel”).
4. Place the server blade back into the enclosure and power it up (“Replacing the server blade”).
Removing and replacing DIMMs
CAUTION: When a single DIMM is removed it must either be replaced with a new matching
DIMM, or the DIMM load order must be adjusted.
For the proper load order for DIMMs, see “Installing DIMMs” (page 32) .
Removing DIMMs
1. Power down the server blade and remove it from the server blade enclosure (“Preparing
the server blade for servicing”).
2. Remove the access panel (“Removing the server blade access panel”).
3. Locate the DIMM slots on the server blade system board (“DIMMs”).
4. Remove the DIMM baffle (“Removing the DIMM baffle”).
5. Open the DIMM slot latches.
6. Remove the DIMM from the slot.
IMPORTANT: DIMMs do not seat fully if turned the wrong way.
Replacing DIMMs
See “Installing DIMMs” (page 32).
78 Removing and replacing components