Specifications

2. Lift the battery straight up to remove it from the battery mounting bracket.
3. Push the battery cable down and towards the rear of the server blade to push it
out of the battery bracket's C-hook.
4. Remove the battery mounting bracket from the mezzanine card or mezzanine card
blank by pulling straight up on the bracket and lifting the bracket out of the server.
• Slot 3
1. Lift the BBWC battery straight up to remove it from the battery mounting bracket.
2. Push the battery cable down and towards the rear of the server blade to push it
out from under the battery bracket's C-hook.
6. Pull straight up on the cache module to remove it from the controller.
7. Lift the cache module and the attached battery out of the server blade.
CAUTION: If you need to remove the cache module to transfer data the battery must remain
connected so that the data is preserved.
8. If you will be replacing the cache module, unplug the battery cable from the cache module's
battery connector (“Replacing the 512MB cache module”).
Removing the battery mounting bracket
1. Power down the server blade and remove it from the server blade enclosure (“Preparing
the server blade for servicing”).
2. Remove the access panel (“Removing the server blade access panel”).
3. Remove the DIMM baffle (“Removing the DIMM baffle” (page 77))
4. Remove any mezzanine card installed in slot 2 (“Removing a mezzanine card”).
5. If installed, remove the BBWC battery (“Removing the BBWC battery”).
Removing upgrade components 111