Specifications

3. Remove the DIMM baffle (“Removing the DIMM baffle”).
4. If the P700m controller is in mezzanine 1, and the battery cable is not already plugged into
the cache module:
a. Remove any mezzanine card installed in slot 2 so you can access the P700m's cache
module (“Removing a mezzanine card”).
b. Temporarily remove the cache module so you can access the module's battery connector
(“Removing the 512MB cache module”).
5. IMPORTANT: Only use the 11.5 inch battery cable (408658-001).
If it is not already connected, plug the battery cable cache module plug into the cache module
battery connector. Push the battery cable's plug into the battery connector until it snaps into
place.
NOTE: The lip of the battery cable's cache module plug has three tiny tabs that should face
down.
6. If you had to remove the cache module, reinstall it (“Replacing the 512MB cache module”).
7. With the battery cable plug label (contoured side) up line up the plug's thin edges with the
thin slits on the sides of the battery.
NOTE: The BBWC battery should be print side down.
8. Push the battery cable's plug, into the battery connector until it snaps into place.
Replacing the BBWC battery 109