Specifications

4. Temporarily remove any mezzanine card installed in slot 2 (“Removing a mezzanine card”).
NOTE: If you will be installing the BBWC battery, ensure that the cache module is installed
and the battery cable is plugged into the cache module (“Replacing the 512MB cache
module”).
NOTE: If you are not installing the p700m into slot 1, slot 1 must contain either another
mezzanine card or mezzanine card blank.
5. Clip the mounting bracket onto the mezzanine card or mezzanine card blank.
NOTE: If you are installing the p700m into slot 1, slide the bracket loop over the mezzanine
2 post that sticks up through the notch in the edge of the mezzanine card or mezzanine card
blank.
6. Press the bracket thumbscrew clip over the thumbscrew closest to the mezzanine post.
7. Push the remaining bracket foot over the other edge of the mezzanine card or mezzanine
card blank.
WARNING! To avoid damage to the power cable ensure the battery bracket does not pinch
the power cable to the power connectors.
NOTE: Push only enough to anchor the bracket, keeping the bracket level.
8. Replace any mezzanine cards that you had to remove from mezzanine slot 2 (“Replacing a
mezzanine card”).
Replacing the BBWC battery
The BBWC battery snaps onto the battery mounting bracket to secure the battery inside the server
blade.
NOTE: The battery mounting bracket is installed either on top of a mezzanine card in slot 1,
or the mezzanine blank in slot 1, depending upon the customer's configuration. If no card is used
in slot 1, the mezzanine card blank must be installed for the bracket to clip onto.
1. Power down the server blade and remove it from the server blade enclosure (“Preparing
the server blade for servicing”).
2. Remove the access panel (“Removing the server blade access panel”).
108 HP Smart Array P700m/512 Controller