Specifications

4. Remove any mezzanine cards blocking access to the HP Smart Array P700m/512 Controller
(“Removing a mezzanine card”).
5. Plug the smaller battery cable plug into the cache module battery connector.
IMPORTANT: Only use the 11.5 inch battery cable (408658-001).
NOTE: The lip of the battery cable cache module plug has three tiny tabs that should face
down.
6. With the cache module battery connector pointing towards the 3A DIMM slot, line up the
cache module's two connectors with the two corresponding slots on the P700m controller.
7. Press straight down on the cache module until it snaps into place.
NOTE: If the P700m controller is in mezzanine 1, route the battery cable back over the card
and under the DIMM latches, doubling back towards slot 3, sliding the cable under the inner
mezzanine post for slot 3.
8. Replace the battery mounting bracket.
9. If the battery mounting bracket and BBWC were previously installed:
a. Replace the battery mounting bracket (“Replacing the battery mounting bracket”).
b. Position the battery with the print side down and push the end of the battery cable that
is plugged into the battery down under the battery mounting bracket's C-hook, routing
the cable so its battery end is on the side of the hook that is away from slot 3.
c. Push the other end of the battery down between the two restraining clips.
10. Replace any mezzanine cards that you had to remove from mezzanine slot 2 (“Replacing a
mezzanine card”).
NOTE: If the P700m controller is installed in mezzanine slot 3, tuck the cable between the
battery mounting bracket and slot 3.
Replacing the battery mounting bracket
1. Power down the server blade and remove it from the server blade enclosure (“Preparing
the server blade for servicing”).
2. Remove the access panel (“Removing the server blade access panel”).
3. Remove the DIMM baffle (“Removing the DIMM baffle”)
Upgrading or replacing controller options 107