Specifications
Table Of Contents
- HP Integrity BL860c Server Blade User Service Guide
- Contents
- About This Document
- 1 Overview
- 2 General Site Preparation Guidelines
- 3 Installing the Server Blade Into the Enclosure
- Safety Information
- Installation Sequence and Checklist
- Unpacking and Inspecting the Server Blade
- Installing Additional Components
- Installing and Powering On the Server Blade
- Accessing the Integrated Lights Out 2 Management Processor
- Configuring the iLO 2 MP
- Accessing EFI or the OS from iLO 2 MP
- Server Blade to Enclosure Interface
- LAN / NIC Configuration
- Configuring the HP 2 Internal Port SAS Host Bus Adapter
- Verify and Install the Latest Firmware
- 4 Booting and Shutting Down the Operating System
- 5 Troubleshooting
- Methodology
- Troubleshooting Tools
- Errors and Error Logs
- Supported Configurations
- Troubleshooting Processors/Memory/SBA
- Enclosure Information
- Cooling Subsystem
- Troubleshooting Communications Modules
- Troubleshooting Management Subsystem
- Firmware
- Troubleshooting the Server Interface (System Console)
- Troubleshooting the Environment
- Reporting Your Problems to HP
- 6 Removing and Replacing Components
- Service Tools Required
- Removing and Replacing a Hot-Plug SAS Disk Drive
- Preparing the Server Blade for Servicing
- Removing and Replacing the Server Blade from the Enclosure
- Removing and Replacing the Server Blade Access Panel
- Removing and Replacing Internal Components
- Removing and Replacing DIMMs
- Removing and Replacing a Processor
- Removing and Replacing the SAS Backplane
- Removing and Replacing the Front Display Assembly
- Removing and Replacing the Server Battery
- Removing and Replacing the Mezzanine Cards
- Removing and Replacing a Cache Module
- Removing and Replacing the Low Profile Battery Backed Write Cache (BBWC) Battery
- Removing and Replacing the Trusted Platform Module
- Removing and Replacing the System Board
- A Parts Information
- B Server Upgrades
- C Utilities
- NVRAM Backup Utility
- Extensible Firmware Interface
- EFI/POSSE Commands
- Specifying Parameters
- Using the Boot Option Maintenance Menu
- Integrated Lights Out 2 Management Processor
- Index
connecting to server blade, 42
SUV cable port, 20
SUV cable port location, 22
system board
removing, 142
replacing, 144
system boot options, 68
system configuration menu, 178
system event log, 87, 98, 99
T
ToC button location, 22
tools required, 28, 108
TPM
location, 141
removing, 140
replacing, 141
troubleshooting
basic, 88
BMC and MP firmware, 105
communications modules, 104
environment, 106
management subsystems, 105
memory, 103
methodology, 87
online support, 107
overview, 86
phone support, 107
processors, 102
reporting problems to HP, 106
SBA, 104
system console, 106
using the iLO 2 MP, 101
U
UID LED, 88
unit identification (UID) LED, 21
unit identification (UID), LEDs, 88
unpacking the server blade, 27
V
virtual power button, 110
vMedia, 68
VPD information for EFI driver and RISC firmware, 53
W
weight of server blade, 14
Windows
booting, 79
shutting down, 80
shutting down from the command line, 81
Special Administration Console, 80
wrist strap, antistatic, 26
Z
ZIF socket, 30, 31, 116, 117
184 Index