User's Manual

Instant Capacity Software Validation
On HP-UX Systems
The Instant Capacity software (HP-UX product B9073BA) is installed by HP manufacturing on
instantly ignited HP-UX systems. The Instant Capacity software can also be installed by an HP
service representative on existing (supported) HP-UX enterprise servers as an add-on.
NOTE: The Instant Capacity software is automatically installed when the HP-UX 11i v3, 11i
v2, or 11i v1 Operating Environment (OE) is installed.
To verify the Instant Capacity software is installed on your system, execute the following HP-UX
command:
/usr/sbin/swlist -l product iCOD
Output similar to the following is displayed:
iCOD B.11.23.09.00 HP-UX iCOD Instant Capacity
To verify that the Instant Capacity software installation has not been corrupted, execute the
following HP-UX command:
/usr/sbin/swverify iCOD
The command will display the message Verification succeeded.
On OpenVMS Systems
On OpenVMS systems, the Instant Capacity software is automatically installed on partitionable
systems when the OpenVMS Version 8.3 or later operating system is installed. You should not
need to install the Instant Capacity software separately on OpenVMS systems. Onsite Instant
Capacity installation by an HP service representative after the initial installation of OpenVMS
Version 8.3 is not an option for OpenVMS systems.
To verify that the Instant Capacity software is installed and configured, run the following
commands:
$ @sys$manager:ICAP$CLI_UTILS.COM CONFIG_CHECK
$ show log ICAP$CONFIGURED
"ICAP$CONFIGURED" = "TRUE" (LNM$JOB_nnnnnnnn)
42 Getting Started