User's Manual

System contact email: This field displays the email address for the person who
should receive configuration change notification and
exception reports for the local system. This field is set via
the icapmodify -c command.
From email: This field displays the email address that will be specified
as the sender of all Instant Capacity initiated email
correspondence for the local system. This field is set via
the icapmodify -f command. If not set, email will be
sent from the adm user on the local system.
Asset reporting: This field indicates if the Instant Capacity software on the
local system is presently configured to send email asset
reports to HP. This is configured using the icapnotify
-a command.
Temporary capacity warning period: This field displays the number of days constituting the
temporary capacity warning period for the complex. When
the temporary capacity balance is projected to be depleted
within this number of days, a warning message is sent by
email to the system contact and to root. The value of the
warning period can be set using the icapmodify -w
command.
Exception Status: This field indicates if the complex is presently in an
exception state. A complex is usually in an exception state
when the number of active components of a given type
(cores, cells, memory) exceeds the number of available
usage rights for that component type. The one exception
is that the number of active cores is allowed to exceed the
number of core usage rights as long as there is a sufficient
positive balance of temporary capacity. A negative
temporary capacity balance is always an exception state.
Information displayed for a GiCAP group
The following status information is displayed when the system is a member of a GiCAP group.
Member <mname> in GiCAP group
<gname>
This section heading identifies the member name
(<mname>) and the name of the GiCAP group (<gname>)
that includes this system as a member.
Active Group Manager: This field identifies the name of the active Group Manager
system where you can get more detailed information about
the group, by invoking the icapmanage command (see
icapmanage(1M)).
Standby Group Manager: This field identifies the name of the standby Group
Manager system, if a standby has been defined for the
group. The standby Group Manager has the ability to take
control of the group if the active Group Manager should
become unavailable for any reason. The field is displayed
as “N/A” if no standby Group Manager has been defined
for the group.
Borrowed/Loaned core usage rights: This field identifies the count of core usage rights that were
either borrowed from or loaned to the GiCAP group. This
value must be 0 in order to remove the member from the
GiCAP group.
Borrowed/Loaned cell usage rights: This field identifies the count of cell board usage rights
that were either borrowed from or loaned to the GiCAP
183