Virtual Connect Enterprise Manager 7.1 CLI Guide

Table 17 Parameter descriptions for -set fcoe-connection (continued)
OptionalRequiredDescriptionParameter
BIOS boot order. Valid
values include the following:
• usebios
• primary
• secondary
• disabled
Only one boot parameter is
allowed per FCoE
connection.
x
IMPORTANT: The
-bootport parameter is
required only when the
bootpriority parameter
is set to either primary or
secondary.
Specifies the target World
Wide Port Name (WWPN)
of the controller interface on
the Fibre Channel storage
target. The port name is a
64-bit identifier in the
following format:
NN:NN:NN:NN:NN:NN:NN:NN
-bootport
The designation N stands for
a hexadecimal number.
x
IMPORTANT: The
-bootlun parameter is
required only when the
bootpriority parameter
is set to either primary or
secondary.
Specifies the logical unit
number (LUN) of the volume
used for SAN boot. Valid
values include an integer
from 0 to 255 or 16
hexadecimal digits (HP-UX
only).
-bootlun
Output
The function returns the result of the set operation or a jobid if –nb is specified.
Examples
• Change the fabric of a FCoE SAN fabric connection:
vcemcli -set fcoe-connection –profilename MyProfile –portnumber 1
–fabric SAN_5
• Set a FCoE SAN fabric connection to unassigned:
vcemcli -set fcoe-connection –profilename RedProfile –portnumber 2
–fabric ""
• Modify the FCoE connection and set the speed to 5 Gb:
vcemcli -set fcoe-connection –profilename MyProfile –portnumber 1
–speedtype custom –customspeed 5000
• Change the SAN boot priority and set additional boot parameters:
vcemcli -set fcoe-connection –profilename BlueProfile –portnumber
1 -bootpriority primary –bootport 50:06:0B:00:00:C2:62:00 –bootlun
5
Minimum required role-based security
VCEM Group Operator
46 Using VCEM commands