Virtual Connect Enterprise Manager 7.1 CLI Guide

set fcoe-connection
The -set fcoe-connection command modifies an existing FCoE connection.
Syntax
set fcoe-connection –profilename <profileName>
-portnumber <PortNumber>
[-fabric <FabricName>]
[-speedtype <1Gb|2Gb|4Gb|8Gb|Custom|Disabled>]
[–customspeed <100–10000>]
[–bootpriority <priority>]
[–bootport <portName>]
[–bootlun <LUN>]
Parameters
Table 17 Parameter descriptions for -set fcoe-connection
OptionalRequiredDescriptionParameter
xSpecifies the name of the
profile to which the FcOE
connection will be assigned.
-profilename
xSpecifies the port number of
the connection.
-portnumber
xSpecifies the name of the
FCoE SAN fabric to
-fabric
associate with the
connection.
xSpecifies the requested
operational speed for the
-speedtype
server port. Valid values
include 1Gb, 2Gb, 4Gb,8Gb,
custom, and disabled. If
the speed type is custom,
you can configure any
speed from 100 Mb to 10
Gb in 100 Mb increments.
The -customspeed
parameter is required if the
speed type is custom and
is the user-defined speed for
the server port. Valid values
include 100 Mb to 10 Gb
configured in 100 Mb
increments. The acceptable
value is 100 Mb/s to
10,000 Mb/s.
x
IMPORTANT: The
-customspeed parameter
is required if the speed type
is custom.
Specifies the user-defined
speed for the server port.
Valid values include 100
Mb to 10 Gb configured in
100 Mb increments. The
acceptable value is 100
Mb/s to 10,000 Mb/s.
-customspeed
xControls whether the FC
HBA port is enabled for
-bootpriority
SAN boot and affects the
set fcoe-connection 45