User's Guide

Configuring HyperFabric
Configuring HMP for Transparent Local Failover Support
Chapter 4
89
Deconfiguring HMP for Local Failover support - Using SMH
To use SMH to deconfigure HMP for Local Failover support, complete the following
steps:
Step 1. Start SMH.
Step 2. Select the “Networking and Communications” area.
Step 3. Select the “Network Interfaces” area.
Step 4. Select “HyperFabric”.
All HyperFabric adapter card pairs installed in the system are listed.
Step 5. Pull down the “Actions” menu and select Deconfigure Local Failover for HMP to remove all
the card pair entries from the /etc/rc.config.d/clic_global_conf file. In the next confirmation
window that pops-up, select YES to confirm it.
If you select NO. you remain in the main “HyperFabric Configuration” screen.
Step 6. Exit SMH.