User's Guide

Configuring HyperFabric
Configuring HyperFabric with ServiceGuard
Chapter 4
81
RESOURCE_UP_VALUE =UP
Configuring ServiceGuard with HyperFabric Using SMH
You must perform the following steps when using SMH to configure the HyperFabric
Resource Monitor with ServiceGuard:
smh
Clusters
High Availability Clusters
Cluster Configuration (go through all the steps to create a
cluster)
Package Configuration
Create/Add Package (if creating new packages)
Specify Package Name and Nodes
Specify Package SUBNET Address
Specify Package Services
Specify Package Failover Options
Specify Package Control Script Location
Specify Package Control Script Information
Specify Package Resources Dependencies
Add
Resource Name
(Navigate the Resource Subclass by double-clicking on
/net until /net/interfaces/clic/ status shows up in the
selection box Resource Name,then select it and click OK.)
Resource Parameters
- Input the Resource Polling Interval (for example, 10 seconds).
- Select “UP” from the “Available Resource Values” and click “Add”.
- Click OK to accept the values.
Configuring ServiceGuard for HyperFabric Relocatable IP Addresses
If you want to use relocatable IP addresses, configure the relocatable IP addresses with
the IP[n] command in the package control script.
For example, to configure the relocatable address 192.0.0.3 for adapter 0 and 192.0.8.5 for
adapter 1, specify this:
IP[0]= 192.0.0.3
IP[1]= 192.0.8.5