User's Guide

Installing HyperFabric

Installing the Software

Chapter 3

Note that these lines are used by the HyperFabric software—and are not comments—so

do not remove them from the ﬁle.

Step 14. Verify that all installed HyperFabric adapters have a software state of “CLAIMED,” by

running the ioscan -nf -C clic command.

Note: A check is also done to make sure all of the HyperFabric adapters have been

claimed when clic_init is activated or when SMH is used to conﬁgure HyperFabric.

Step 15. If one or more HyperFabric switches are included in the conﬁguration, go to the next

section of this chapter, “Installing HyperFabric Switches”, otherwise, go to Chapter 4,

“Conﬁguring HyperFabric,” on page 61.