User's Guide

Installing HyperFabric
Installing the Software
Chapter 3
47
Installing the Software
This section describes the HyperFabric file structure and the steps necessary to load the
software. The software must be installed on each instance of the HP-UX operating
system in the fabric.
File Structure
The HyperFabric file structure is shown in Figure 3-1 below. Note that the structure is
shown for informational purposes only. The user cannot modify any of the files or move
them to a different directory.
Figure 3-1 HyperFabric File Structure
The commands and files used to administer HyperFabric typically have a prefix of
clic_. CLIC stands for CLuster InterConnect, and it is used to differentiate those
HyperFabric commands/files from other commands/files. For example, the HyperFabric
command clic_init is different from the HP-UX init command.
Each of the files shown in Figure 3-1 above is briefly described below:
• /etc/opt/resmon/dictionary/clic_01
The HyperFabric dictionary file for the Event Monitoring Service (EMS).
• /etc/rc.config.d/clic_global_conf
/
/etc
/rc.config.d
/clic_global_conf
/sbin
/init.d
/clic
/var/adm
/clic_log
/clic_ip_drv.trc
/usr
/conf
/lib
/libclic_dlpi_drv.a
/libha_drv.a
/master.d
/clic
/opt
/clic
/bin
/clic_diag
/clic_init
/clic_mgmtd
/clic_mond
/clic_start
/clic_stat
/lib
/libclic_mgmt.a
/firmware
/clic_fw
/clic_log.old
/opt
/resmon
/dictionary
/clic_01
/clic_ping
/clic_shutdown
/clic_fw_db
/clic_dump
/OLDclic_log
/share
/man
/man1m.Z
/clic_probe
/clic_fw_1x32c
/clic_fw_4x8c
/clic_fw_4x32c
/clic_fw_hf28c
/clic_fw_hf232c
/clic_ip_drv.trc0
/clic_ip_drv.trc1