User's Guide

Managing HyperFabric
Stopping HyperFabric
Chapter 5
111
Using SMH
To use SMH to stop HyperFabric on a local HP 9000 system running HP-UX 11i v3,
follow these steps:
Step 1. Start SMH.
Step 2. Select the “Networking and Communications” area.
Step 3. Select the “Network Interfaces” area.
Step 4. Select “HyperFabric.”
Step 5. Pull down the “Actions” menu and select Stop HyperFabric. Note that if HyperFabric is
not running on the system, Stop HyperFabric is grayed out and you cannot select it.
When HyperFabric stops, a confirmation message displays. Also, the status
“HyperFabric: Not running” is displayed above the adapter configuration area of the
screen.
Step 6. Exit SMH.