Setup and Install

Configuring HyperFabric
Deconfiguring a HyperFabric Adapter with SAM—HP-UX 11.0 and 11i 0nly
Chapter 4
96
Deconfiguring a HyperFabric Adapter with
SAM—HP-UX 11.0 and 11i 0nly
To use SAM to deconfigure a HyperFabric adapter on an HP 9000 system running
HP-UX 11.0 or 11i, follow these steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.
Step 3. Select “HyperFabric.”
All HyperFabric adapters installed in the system are listed. Installed adapters that are
configured show Configured in the “Status” field, and installed adapters that are not
yet configured show Not Configured in the “Status” field. You can deconfigure only an
adapter with a status of Configured.
Step 4. Highlight the adapter you want to deconfigure.
Step 5. Pull down the “Actions” menu and select Deconfigure Adapter.
Step 6. In the pop-up window, if you want to deconfigure the adapter, select OK to confirm it.
If you do not want to deconfigure the adapter, select Cancel.
Step 7. If you selected OK, the entry for the adapter is deleted from the HyperFabric
configuration files (/etc/rc.config.d/clic_global_conf and
/etc/rc.config.d/netconf).
If you selected Cancel, you remain in the main “HyperFabric Configuration” screen.
Step 8. Exit SAM.