Setup and Install

Configuring HyperFabric
Doing the Configuration
Chapter 4
95
• If you have just created the global configuration file on the local node for the first
time (and you are not configuring MC/ServiceGuard), run clic_start or use SAM to
start HyperFabric.
• If you have just changed an existing configuration file on the node, run
clic_shutdown or use SAM to stop HyperFabric, and then run clic_start or use
SAM to start HyperFabric. Until you do those two things, your configuration changes
will not take effect.
See “Stopping HyperFabric” on page 99 and “Starting HyperFabric” on page 85 for more
information.