Setup and Install

Installing HyperFabric
Installing HyperFabric Switches
Chapter 3
67
❏ After the HyperFabric switch is mounted in the rack, you attach the various cables
to the switch.
To avoid damage to any of the cables, follow these guidelines:
— If your cables have dust caps over the connectors, keep them in place until you
are ready to connect them. This prevents dirt and oils from soiling any important
surfaces.
— Be careful not to stretch, puncture, or crush the cable.
To install a HF1 switch see the next section, “Steps for Installing the HF1 Switch”.
To install an HF2 switch, see “Installing the HF2 Switch” on page 76.