Setup and Install

Troubleshooting HyperFabric
Useful Files
Chapter 5
110
/var/adm/clic_fw.dumpx
This is the default file for a memory dump of an HyperFabric adapter, created when
the clic_diag -d command is run without specifying an output file.
• /etc/rc.config.d/netconf
This file contains IP-related configuration information for all of the networking
adapters installed in the HP 9000.
IMPORTANT: clic_init and SAM modify this file, adding some
HyperFabric-related lines that end with the characters #clic. These lines are used
by the HyperFabric software—and are not comments—so do not remove them from
the file.
• /etc/services
This is the system service name database.
IMPORTANT: These two HyperFabric-related lines must be in this file:
— hp-clic 3384/tcp #clic management daemon
— hp-clic 3384/udp #clic switch management
These lines are used by the HyperFabric software—and are not comments—so do not
remove them from the file.