Setup and Install

Managing HyperFabric
Stopping HyperFabric
Chapter 4
100
Using SAM—HP-UX 11.0 and 11i 0nly
To use SAM to stop HyperFabric on a local HP 9000 system running HP-UX 11.0 or 11i,
follow these steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.
Step 3. Select “HyperFabric.”
Step 4. Pull down the “Actions” menu and select Stop HyperFabric. Note that if HyperFabric is
not running on the system, Stop HyperFabric is grayed out and you cannot select it.
When HyperFabric stops, a confirmation message displays. Also, the status
“HyperFabric: Not running” is displayed above the adapter configuration area of the
screen.
Step 5. Exit SAM.