Setup and Install

Managing HyperFabric
Displaying Status and Statistics
Chapter 4
95
• Example 4
If the local node is bently6, and you want to display the VRIDs, IP addresses, switch
hopcounts, and physical routes for each HyperFabric adapter in bently6, issue this
command:
clic_stat -d VRID
The generated output if the nodes are connected in a Point-to-Point configuration
could look like this:
============================================================================
Date: Sat Aug 5 16:08:12 2000
Node: bently6.corp4.com
----------------------------------------------------------------------------
============================================================================
Adapter : clic0
----------------------------------------------------------------------------
VRID IP Address Switch Hopcount Route Id Physical route
----------------------------------------------------------------------------
1 192.0.0.1 0 Point to Point Connection
2 192.0.0.2 0 Point to Point Connection
12 192.0.0.12 0 Point to Point Connection
13 192.0.0.13 0 Point to Point Connection
============================================================================
Adapter : clic2
----------------------------------------------------------------------------
VRID IP Address Switch Hopcount Route Id Physical route
----------------------------------------------------------------------------
1 192.0.0.1 0 Point to Point Connection
2 192.0.0.2 0 Point to Point Connection
12 192.0.0.12 0 Point to Point Connection
13 192.0.0.13 0 Point to Point Connection
============================================================================
The generated output if the nodes are connected through a switch could look like
this: