Setup and Install

Managing HyperFabric
Starting HyperFabric
Chapter 4
85
Starting HyperFabric
HyperFabric is started in one of these three ways:
• As part of the normal local node boot process (HP 9000 system).
• By running the HyperFabric clic_start command (described below).
• By starting HyperFabric through SAM (described in “Using SAM—HP-UX 11.0 and
11i 0nly” on page 86).
HyperFabric needs to be started in the following situations:
• If HyperFabric hardware and software have just been installed on the system and
the clic_init command has been used to configure the HyperFabric adapters on
this node.
• If the HyperFabric configuration has been changed by using the clic_init
command or using SAM (HP-UX 11.0 and 11i 0nly). In this situation, you must have
run clic_shutdown or used SAM to stop HyperFabric (HP-UX 11.0 and 11i 0nly),
before restarting HyperFabric.
• If a new HyperFabric adapter has been added to a system online and configured
using clic_init. In this situation, it is not necessary to run clic_shutdown before
running clic_start (see “Online Addition and Replacement—HP-UX 11i Only” on
page 55in Ch. 3 of this user guide).
NOTE Starting HyperFabric launches the HyperFabric CLuster InterConnect (CLIC) daemon
(clic_mgmtd). This daemon process must be running for the HyperFabric product to
operate correctly. It is possible that other daemons will be running, but it is essential
that at least one CLIC daemon is running. To check if a CLIC daemon is running, use
the following command:
ps -ef | grep clic
If the CLIC daemon is not running, start the HyperFabric subsystem by executing the
following command:
/opt/clic/bin/clic_start
Using the clic_start Command
Run the clic_start command on each node to start the HyperFabric management
process on that node.
If you include /opt/clic/bin in your PATH statement, you can run the command as it is
shown below. Otherwise, you must include /opt/clic/bin as part of the command
name (that is, /opt/clic/bin/clic_start).
You must be logged in as root to run this command.
The syntax is as follows:
clic_start