Setup and Install

Configuring HyperFabric
Configuring HyperFabric with MC/ServiceGuard
Chapter 4
105
NOTE You should configure HyperFabric with MC/ServiceGuard before running the
clic_start command or using SAM to start HyperFabric.
Configuring MC/ServiceGuard with HyperFabric Using the ASCII File
When using the MC/ServiceGuard commands (for example, cmapplyconf) to specify the
use of the HyperFabric Resource Monitor, the section of the package ASCII configuration
file that has the keyword RESOURCE_NAME must be uncommented and set to the following
values:
RESOURCE_NAME /net/interfaces/clic/status
RESOURCE_POLLING_INTERVAL 10
RESOURCE_UP_VALUE =UP
Configuring MC/ServiceGuard with HyperFabric Using SAM
You must perform the following steps when using SAM to configure the HyperFabric
Resource Monitor with MC/ServiceGuard:
sam
Clusters
High Availability Clusters
Cluster Configuration (go through all the steps to create a
cluster)
Package Configuration
Create/Add Package (if creating new packages)
Specify Package Name and Nodes
Specify Package SUBNET Address
Specify Package Services
Specify Package Failover Options
Specify Package Control Script Location
Specify Package Control Script Information
Specify Package Resources Dependencies
Add
Resource Name
(Navigate the Resource Subclass by double-clicking on
/net until /net/interfaces/clic/ status shows up in the
selection box Resource Name,then select it and click OK.)
Resource Parameters
- Input the Resource Polling Interval (for example, 10 seconds).
- Select “UP” from the “Available Resource Values” and click “Add”.
- Click OK to accept the values.