Administrator's Guide

Configuring HyperFabric
Deconfiguring a HyperFabric Adapter with SAM
Chapter 4 83
Deconfiguring a HyperFabric Adapter with
SAM
To use SAM to deconfigure a HyperFabric adapter on an HP 9000 system
running HP-UX 11i v2, complete the following steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.
Step 3. Select “HyperFabric.”
All HyperFabric adapters installed in the system are listed. Installed
adapters that are configured show Configured in the “Status” field, and
installed adapters that are not yet configured show Not Configured in
the “Status” field. You can deconfigure only an adapter with a status of
Configured.
Step 4. Highlight the adapter you want to deconfigure.
Step 5. Pull down the “Actions” menu and select Deconfigure Adapter.
Step 6. In the pop-up window, if you want to deconfigure the adapter, select OK to
confirm it.
If you do not want to deconfigure the adapter, select Cancel.
Step 7. If you selected OK, the entry for the adapter is deleted from the
HyperFabric configuration files (/etc/rc.config.d/clic_global_conf
and /etc/rc.config.d/netconf).
If you selected Cancel, you remain in the main “HyperFabric
Configuration” screen.
Step 8. Exit SAM.
NOTE If you have configured HMP for Transparent Local Failover support and
if you select Deconfigure Adapter, HyperFabric will verify if the
selected adapter is configured to be part of any card pair. If yes, the user