Administrator's Guide

Conﬁguring HyperFabric

Performing the Conﬁguration

Chapter 480

If you do not specify any of the above parameters, the online help for

clic_init is displayed.

After you have entered the information for all the adapters in the node

and all of the switches (if any) in the fabric, a summary of the

conﬁguration information is displayed.

Once clic_init has ﬁnished, you do one of the following things:

• If you want to conﬁgure HyperFabric with ServiceGuard, complete

the conﬁguration described in “Conﬁguring HyperFabric with

ServiceGuard” on page 87, then run clic_start or use SAM to start

HyperFabric.

• If you have just created the global conﬁguration ﬁle on the local node

for the ﬁrst time (and you are not conﬁguring ServiceGuard), run

clic_start or use SAM to start HyperFabric.

• If you have just changed an existing conﬁguration ﬁle on the node,

run clic_shutdown or use SAM to stop HyperFabric, and then run

clic_start or use SAM to start HyperFabric. Until you do those two

things, your conﬁguration changes will not take effect.

See “Stopping HyperFabric” on page 128 and “Starting HyperFabric” on

page 109 for more information.

Examples of clic_init

Some examples of using the clic_init command are shown below.

• Example 1

To create the global conﬁguration ﬁle on the local node, issue this

command:

$ clic_init -c

• Example 2

To display the online help for the clic_init command, issue this

command:

$ clic_init -?

or this command:

$ clic_init